сервис мануала на FT-1907 не нашел в инете
есть на 1807 там практически все одинаково
Ага, почитал, только все с приборами надо мерять что хотим, просто по "попугаям" не выйдет ...
To enter the Alignment mode, press and hold in the [REV(DW)] and [D/MR(MW)] keys while turning the radio on.
Once the radio is on, release these two key. The transceiver is now in the “Alignment Mode.”
Чтоб войти в режим надо одновременно зажать клавиши [REV(DW)] и [D/MR(MW)] и включить питание.
Уровень порога шумодава
Squelch Threshold Level
Inject a 435.100 MHz signal at a level of –14 dBμ (with 1 kHz modulation @±3.5 kHz deviation) from the RF signal generator.
Rotate the SQL knob to the 10-o’clock position.
Rotate the DIAL knob to set the alignment parameter to “435.100 tL.”
Press the [D/MR(MW)] key to enable adjustment of the “Squelch Threshold Level.”
Press the [D/MR(MW)] key three times.
Press the [D/MR(MW)] key.
Выставление частоты
PLL Reference Frequency
Rotate the DIAL knob to set the alignment parameter to “435.000 rF.”
Press the [D/MR(MW)] key to enable adjustment of the “PLL Reference Frequency.”
Press the PTT switch to activate the transmitter, adjust the DIAL knob so that the counter frequency reading is 435.100 MHz (±200 Hz).
Чуйка типа?
RF Front-end Tuning
Inject a 435.100 MHz signal at a level of –10 dBμ (with 1 kHz modulation @±3.5 kHz deviation) from the RF signal generator.
Rotate the DIAL knob to set the alignment parameter to “435.100 tn.”
Press the [D/MR(MW)] key to enable adjustment of the “RF Front-end Tuning.” Adjust the DIAL knob so that the maximum SINAD.
Press the [D/MR(MW)] key.